300 weeks of pumping!
This is a draft
Testing long time penis ring use....
Notes week 300
* Tuesday: Pump, 10 min at 6 inHg.
* Wednesday morning: Pump, 25 min at 5 inHg.
* Wednesday noon: Edging, 10 min.
* Wednesday afternoon: Pump, 5 min at 6 inHg.
* Thursday morning: Pump, 30 min at 5 inHg. In-cylinder mid-shaft width = 46 mm (new highscore with 1 mm).
* Thursday afternoon: Pump, 15 min at 5 inHg.
Notes week 301
* Monday: Pump, 30 min at 4 inHg.
* Tuesday: Pump, 10 min at 5 inHg.
* Wednesday: Pump, 30 min at 4 inHg.
* Thursday: Pump, 6 min at 6 inHg.
* Friday: Pump, 30 min at 4 inHg. In-cylinder length = 20,5 cm. In-cylinder mid-shaft width = 45 mm. Afterwards MSEG = 14,2 cm.
Current highscores
Without PE
BPEL = 20,5 cm (8.07 in)
MSEG = 14,0 cm (5.51 in)
BEG = 16,5 cm (6.50 in)
BPFL = 12,9 cm (5.08 in)
MSFG = 10,7 cm (4.21 in)
BFG = 11,4 cm (4.49 in)
BPFSL = 21,8 cm (8.58 in)
During pump
In-cylinder length = 21,0 cm (8.27 in) (week 90, 136 and 260)
In-cylinder mid-shaft width = 46 mm.
After pump
BPEL = 20,7 cm (8.15 in)
MSEG = 14,6 cm (5.75 in) (note: measured 15,1 cm week 224, but that seem a little too much)
BEG = 17,4 cm (6.85 in)
With penis ring after pump
MSEG = 14,8 cm (5.83 in)
With penis ring
MSEG = 14,8 cm (5.83 in)
After edging
MSEG = 14,2 cm (5.59 in)
MSEG = Adjustable penis ring with 6 unused pegs (about 13,5 cm)
BEG = 16,7 cm (6.57 in)
BEG = Adjustable penis ring using 1 peg almost fits around base
Notes: Pumping these weeks done with my 2.25" cylinder unless stated otherwise.
In-cylinder lengths are measured with a ruler outside the cylinder, from the penis tip to the seam at the cylinder's top 22,5 cm (8.86 inches) from the base and then doing subtraction.
Appendix: 2.25" cylinder measurements
Wall thickness: 4.9 mm
Outer diameter base: 66.5 mm -> 178.1 mm (7.01 in) inner circumference.
Outer diameter at mid shaft (10 cm up): 61.7 mm -> 163.0 mm (6.42 in) inner circumference.
Outer diameter at corona of glans (16 cm up): 58.9 mm -> 154.3 mm (6.07 in) inner circumference.
↧
Week 300 - ?
↧